Liqui Moly Engine Flush Shooter

Liqui Moly Engine Flush highly effective cleaning fluid. Removes troublesome deposits from inside the engine. Dissolves sludge and lacquer formers. All types of oil-soluble and oil-insoluble residues are brought into suspension and removed during the next oil change. This allows the clean engine and fresh oil to realize their full potential.

Flushes out and cleans the oil circuits of motorcycles with 4-stroke gasoline engines. The frequency of use is dependent on the degree of contamination of the oil circuit and on the quality of the oil used. 80 ml (1 can) is sufficient for 0.8 – 2 l of oil.

Liqui Moly Engine Flush Applic­a­tion

80 ml (1 can) is sufficient for 0.8 – 2 l of oil. Add to warm motor oil before oil change. Then allow the engine to idle for approx. 10 minutes. With manual transmissions, press the clutch lever several times, holding it for a few seconds each time. Then change the oil and the filter.

Compatible with commercially available motor oils. Suitable for use on motorcycles with wet clutches.

Liqui Moly Engine Flush Shooter – The Secret to a Healthier Engine

When it comes to engine maintenance, most riders only think about changing oil regularly. But what about the sludge, dirt, and harmful residues that remain inside your engine even after an oil change? That’s where Liqui Moly Engine Flush Shooter comes in.

This German-engineered formula is a pre-oil change cleaner designed specifically for motorbikes. It helps eliminate internal contaminants that can harm your engine over time. Whether you’re a daily commuter or a long-distance rider, maintaining a clean engine is crucial for performance, fuel economy, and engine longevity.

What Does It Do?

Liqui Moly Engine Flush Shooter works by dissolving harmful deposits, sludge, and dirt inside your engine before you drain the old oil. You simply pour it into your engine oil, run the engine for about 10 minutes, and then perform your oil change. The result? A thoroughly cleaned engine interior, ready for fresh oil.

Key Benefits:

✅ Cleans the entire oil circulation system
✅ Prevents premature engine wear
✅ Improves compression and performance
✅ Extends engine life and enhances oil effectiveness
✅ Suitable for all 4-stroke motorbike engines

Why Should You Use It?

Over time, engines accumulate sludge and carbon deposits that regular oil changes can’t remove. These residues reduce efficiency, increase fuel consumption, and may even lead to engine damage. Liqui Moly’s Engine Flush Shooter ensures your new oil can do its job effectively by cleaning the engine beforehand.

If you’re using high-performance synthetic oils, using a flush beforehand ensures that no leftover contaminants mix with the new oil. This is especially important for high-revving engines found in modern bikes.

How to Use:

1. Ensure your engine is warm (but not hot).

2. Pour the 80ml can of Engine Flush Shooter into the engine oil fill point.

3. Let the engine idle for 10 minutes (do not rev).

4. Turn off the engine and perform a complete oil and filter change.

Safe and Trusted

Made in Germany, Liqui Moly is known for its high-quality automotive chemicals. The Flush Shooter is compatible with most 4-stroke motorbike engines and is safe for catalytic converters.

Available now at Mototechbd!
📞 Call to order: 01844-124411
🏍️ Make your next oil change count – give your engine a fresh start with Liqui Moly Engine Flush Shooter.